Submenu Function
Indicates the access points where security is set.
If you select an access point where security has not been set, the
Wireless LAN menu is displayed.
If you select an access point where security has been set, the
Security menu is displayed. Select a type of security according to
the security settings for the access point.
Wired LAN menu
Submenu Function
IP Settings
You can make settings related to the following addresses.
DHCP: Set to On to configure the network using DHCP. If this is
set to On, you cannot set any more addresses.
IP Address: Enter the IP address assigned to the projector. You
can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask: Enter the projector's subnet mask. You can enter a
number from 0 to 255 in each field of the address. However, the
following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: Enter the IP address for the gateway for the
projector. You can enter a number from 0 to 255 in each field of
the address. However, the following Gateway Address cannot be
used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
List of Functions
157
To Next Page
Loading...
