Submenu Function
IPv6 Settings
Perform settings to use the IPv6 protocols.
a
• The following functions support IPv6
protocols.
- Epson Web Control
- PJLink
• When setting the IPv6 address manually,
make settings in Advanced from Epson
Web Control.
s "Changing Settings Using a Web
Browser (Epson Web Control)" p.215
IPv6: Set this to On when using IPv6 protocols. Make sure
one link local address is set when using IPv6. This is
composed of the interface ID created from fe80:: and the
projector's MAC address.
Auto Configuration: Set this to On to automatically acquire
an IPv6 address from RA (Router Advertisement). The
address is composed as shown below.
• Stateless Address (0 to 6): Created automatically by
combining the prefix acquired from the RA (Router
Advertisement) and the interface ID created from the
projector's MAC address.
• Stateful Address (0 to 1): Created automatically from the
DHCP server using DHCPv6.
Use Temporary Address: Set this to On to temporarily
validate the IPv6 address (0 to 1) when Auto Configuration
is On.
* This can only be selected when Connection Mode is set to Advanced.
Type of security
When the optional wireless LAN unit is attached and being used in
Advanced connection mode, it is strongly recommended that you set
security.
WPA is an encryption standard that improves the security for wireless
networks. The projector supports TKIP and AES encryption methods.
WPA also includes user authentication functions. WPA authentication
provides two methods: using an authentication server, or authenticating
between a computer and an access point without using a server. This
projector supports the latter method, without a server.
a
For setting details, follow the instructions from your network
administrator.
Search Access Point screen
Detected access points are displayed in a list.
Submenu Function
Refresh
Searches for the access point again.
Indicates an already set access point.
List of Functions
156
To Next Page
Loading...
