Epson EB-L1075U - Adjusting the Image; Hue, Saturation, and Brightness Adjustment

Aspect Mode Explanation
Full
Projects at the full size of the projected screen.
H-Zoom
Projects by enlarging the input image to the full width of
the projected screen while retaining the aspect ratio. Areas
that exceed the edges of the projected screen are not
projected.
V-Zoom
Projects by enlarging the input image to the full height of
the projected screen while retaining the aspect ratio. Areas
that exceed the edges of the projected screen are not
projected.
Native
Projects to the center of the projected screen at the
resolution of the input image. Areas that exceed the edges
of the projected screen are not projected.
a
• The available aspect ratios differ depending on the input signal from
the connected device.
• You can also set the aspect ratio from the Configuration menu.
s
Signal - Aspect p.142
• If parts of the computer image are missing, set the Resolution
setting to Wide or Normal from the Configuration menu, according
to the resolution of the computer.
s
Signal - Resolution p.142
Adjusting the Image
Hue, Saturation, and Brightness adjustment
You can adjust the Hue (tint), Saturation (vividness), and Brightness of
the six axes R (red), G (green), B (blue), C (cyan), M (magenta), and Y
(yellow) according to your preferences.
a
Press the [Menu] button while projecting.
b
Select Advanced from Image, and then press the [ ] button.
c
Select RGBCMY, and then press the [ ] button.
d
Use the [ ][ ] buttons to select the color you want to adjust,
and then press the [
] button.
e
Use the [ ][ ] buttons to select the item, and then use the
[
][ ] buttons to make the adjustments.
Each time you press the [ ] button, the adjustment screen changes.
f
To complete the corrections, press the [Menu] button.
Adjusting the Projected Images
81