Submenu Function
Address 1 Set-
ting/ Address 2
Setting/ Address
3 Setting
Set the destination email addresses for the notification email, and
the notification content. You can register up to three
destinations. You can enter up to 64 single-byte alphanumeric
characters. You can enter up to 32 characters on the
Configuration menu. When entering more than 32 characters,
use your Web browser to enter the text. ( " ( ) , : ; < > [ \ ] and spaces
cannot be used.)
s "Changing Settings Using a Web Browser (Epson Web
Control)" p.215
SNMP
Set to On to monitor the projector using SNMP. To monitor the
projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is Off.
Trap IP Address
1/ Trap IP Ad-
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Community
Name
Set the community name of SNMP. You can enter up to 32 single-
byte alphanumeric characters. (Spaces and symbols cannot be
used.)
PJLink Notifica-
tion
Set this to On to use the PJLink notification function.
Notified IP Ad-
dress
Enter the IP address of the computer to which you want to send
notifications of the projector's operating status using the PJLink
notification function.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Others menu
Submenu Function
Secure HTTP
To strengthen security, communication between the projector
and computer in Epson Web Control is encrypted. When setting
security with Epson Web Control, we recommend setting this to
On.
Web Server Cert.
Imports the Web server certificate used in Secure HTTP.
Priority Gateway
For the priority gateway, select either Wired or Wireless.
AMX Device Dis-
covery
When you want to allow the projector to be detected by AMX
Device Discovery, set this to On. Set this to Off if you are not
connected to an environment controlled by a controller from
AMX or AMX Device Discovery.
Crestron Con-
nected
Set this to On only when monitoring or controlling the projector
over the network using Crestron Connected
®
. Otherwise, set
this to Off.
s "About Crestron Connected
®
" p.228
Changes in projector settings take effect upon restarting.
When this is set to On, you cannot use the Message Broadcasting
feature in Epson Projector Management.
List of Functions
159
To Next Page
Loading...
