Caution
• Do not disconnect the power cord from the projector while the
settings are being written. If the power cord is disconnected, the
projector may not start correctly.
• Do not disconnect the USB flash drive from the projector while the
settings are being written. If the USB flash drive is disconnected, the
projector may not start correctly.
d
When writing completes normally, the projector enters standby
status.
Power
Blue - On
When the projector is in standby status, remove the USB flash
drive.
Setup by Connecting the Computer and Projector
with a USB Cable
a
The following operating systems support the batch setup function.
• Windows Vista or later
• Mac OS X 10.7.x or later
Saving settings to a computer
a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the computer's USB port to the projector's Service port
with a USB cable.
c
While holding down the [Esc] button on the remote control or the
control panel, connect the power cord to the projector.
Batch Setup
168
To Next Page
Loading...
