• Moderator Password: Allows you to set an authentication password
for using Epson iProjection when connecting to the projector as a
moderator. Enter four digits for the password. (There is no default
password.)
• Projector Keyword: Lets you turn on a security password to
prevent access to the projector by anyone not in the room with it.
You must enter a displayed keyword using Epson iProjection to
project images and send or receive data.
• Display Keyword: Lets you display a projector keyword on the
projection screen when connecting to the projector using Epson
iProjection.
• Display LAN Info. lets you set the display format for the
projector's network information.
a
Use the displayed keyboard to enter the name, passwords and
keyword. Press [
][ ][ ][ ] buttons on the remote control
to highlight characters and press [Enter] to select them.
f
Select the Wired LAN menu and press [Enter].
g
Assign the IP settings for your network as necessary.
• If your network assigns addresses automatically, select IP Settings
to set the DHCP setting to On.
• If you must set addresses manually, select IP Settings to set the
DHCP setting to Off, and then enter the projector's IP Address,
Subnet Mask, and Gateway Address as necessary.
• If you want to connect the projector to the network using IPv6,
select IPv6 Settings.
s "Wired LAN menu" p.157
a
Press the [ ][ ][ ][ ] buttons on the remote control, and
then select the number you want to enter on the soft keyboard
displayed. Press the [Enter] button to confirm.
h
To prevent the IP address from being displayed on the LAN
standby screen and Home screen, set the IP Address Display
setting to Off.
i
If you have finished making settings, select Setup complete.
Follow the on-screen instructions to save the settings and close
the menu.
Wired Network Projection
122
To Next Page
Loading...
