Submenu Function
Operation
Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
High Altitude Mode: Set this to On if you are using the
projector above an altitude of 1,500 meters.
Auto Source Search: Set to On to automatically detect an
image signal from another source and project the image
when there is no image signal from the current source.
Auto Power On: If it is set to Computer or BNC, the
projector is turned on when the signals are received from
the Computer port or BNC port, even when the projector is
in standby status.
Startup Source: Select the source you want to project when
the projector is turned on in Content Playback mode.
A/V Mute Settings: Perform settings related to A/V mute.
• Fade-in: Specify the number of seconds for fade-in when
displaying an image.
• Fade-out: Specify the number of seconds for fade-out
when hiding an image.
• A/V Mute Timer: When it is set to On, if no operations
are performed for about 2 hours after A/V mute is
activated, the projector turns off automatically.
• A/V Mute Release: When it is set to A/V Mute, you can
release A/V mute only by pressing the [A/V Mute] button
(or by sending an A/V mute Off command).
When set to Any Button, A/V mute is released when any
operation is performed on the projector.
Submenu Function
s "Hiding the Image and Sound Temporarily (A/V
Mute)" p.102
Advanced: The following items can be set.
• Beep: When this is set to On, the confirmation buzzer
beeps to notify you that the power turns on or off, or
cooling down is finished.
• Indicators: When set to Off, the projector's indicators are
turned off, except for abnormality or warning.
• Log Save Destination: Set where you want to save the
operation logs for the projector. Select USB and Internal
Memory to save the logs to the USB flash drive connected
to the projector’s USB-A port. Logs are saved as text files
(.log) on the USB flash drive.
The following logs are saved.
- Error information
- Laser information
- Temperature logs
- Operation logs
• Batch Setup Range: Select All to copy all of the menu
settings using the batch setting function. Select Limited if
you do not want to copy the following settings.
- EDID from the Signal menu
- Network menu
• Lens Type: When using the following lens, select the
model number of the lens.
ELPLS04, ELPLU02, ELPLR04, ELPLW04, ELPLM06,
ELPLM07, ELPLL07
Date & Time: Make system time settings for the projector.
s "Setting the Time" p.44
Lens Calibration: Acquires the information of the lens
installed on the projector.
List of Functions
148
To Next Page
Loading...
