When the projector's indicators turn on as follows, release the [Esc]
button.
Power supply Status Laser Temp
Blue - On Blue - On Orange - On Orange - On
When all of the indicators start flashing, the batch setup file is being
written.
Caution
• Do not disconnect the power cord from the projector while the file is
being written. If the power cord is disconnected, the projector may not
start correctly.
• Do not disconnect the USB flash drive from the projector while the
file is being written. If the USB flash drive is disconnected, the
projector may not start correctly.
When writing completes normally, the projector enters standby
status.
Power
Blue - On
When the projector is in standby status, remove the USB flash
drive.
Batch Setup
166
To Next Page
Loading...
