Epson EB-L1075U - Page 179

Indicator Cause Remedy or Status
Power
supply
Status Laser Temp Filter
Blue -
Flashing
Status
varies
Status
varies
Orange -
Flashing
Status
varies
High Temp Warn‐
ing
This is not an error. However, if the temperature rises too high again, projection stops automatically.
Check the following three points.
• Check that the air filter, air exhaust vent, and air intake vent are clear, and that the projector is not
positioned against a wall.
• Check if the temperature around the air intake is too high.
• If the air filter is clogged, turn off the power, remove the power cord from the electrical outlet, and then
clean or replace them.
s
"Cleaning the Air Filter and Air Intake Vent" p.204
s "Replacing the Air Filter" p.208
Blue -
Flashing
Status
varies
Orange -
Flashing
Status
varies
Status
varies
Laser Warning Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or
the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Blue -
Flashing
Status
varies
Orange -
Flashing
Status
varies
Status
varies
Lens Warning An unsupported lens is attached. Use a supported lens.
s "Optional Accessories and Consumables" p.233
Reading the Indicators
179