Epson EB-L1075U - Page 221

Attention
Do not remove the USB flash drive from the projector or unplug the power
cord in the following situations. Otherwise, data on the USB flash drive may
be corrupted.
• While viewing the Playlist screen
• While viewing the USB flash drive screen
a
Make sure that the projector is in Content Playback mode.
b
Connect your device to the same network as the connected
projector.
c
Start the Web browser on your device. Enter the IP address of the
projector in the address input box of the browser to connect to
the Epson Web Control screen. When entering an IPv6 address,
enclose the address in square brackets [].
The Epson Web Control screen is displayed.
A
You can use this to operate the projector remotely.
B
Edit the playlist you want to play in Content Playback mode.
C
Displays the Timetable screen.
D
Operate the Configuration menus using your finger or mouse.
E
Displays a test pattern.
F
Displays the projector's status.
G
Make advanced settings for the projector.
H
Displays the Crestron Connected operation screen. This is only enabled when
using Crestron Connected.
I
Operate the lens of the projector.
J
Save the data for your playlists to a USB flash drive.
d
Select the item you want to use.
Monitoring and Controlling
221