Attention
• Make sure you secure the following space around the projector so as not to
block the air exhaust vent and the air intake vent.
• When setting up multiple projectors, make sure there is a gap of at least
70 cm between the projectors. Also, make sure that the heat from the air
exhaust vent does not go into the air intake vent.
• Secure the following space when placing a partition between projectors.
Attention
• Do not stack projectors directly on top of each other.
• When using the ceiling mount or the portrait mount, use commercially
available M6 screws (up to a depth of 14 mm) to fix the projector's ceiling
mount fixing points and the mount at four points.
a
• We recommend setting the focus, zoom, and lens shift at least 20
minutes after you start the projection, because images are not stable
right after turning on the projector.
• When adjusting the image height with the vertical lens shift, adjust
by moving the image from the bottom to the top. If it is adjusted
from the top to the bottom, the image position may move down
slightly after adjusting.
Safety Warning and Cautions
5
To Next Page
Loading...
