Item Function
DHCP Select the Enabled check box to use DHCP. The
following address cannot be set if DHCP is enabled.
IP Address Enter the IP address to assign to the currently connected
projector.
Subnet Mask Enter a subnet mask for the projector that is currently
connected on the network.
Default Gateway Enter the gateway address for the currently connected
projector.
Send Click this button to commit changes made to the
Projector.
C
Admin Password
Select the Enabled check box to require a password to open the Tools window.
The following items can be set.
Item Function
New Password Enter the new password when changing the password to
open the Tools window. (The password can contain up
to 26 single-byte alphanumeric characters.)
Confirm Enter the same password as you entered in New
Password. If the passwords are not the same, an error
will be displayed.
Send Click this button to commit changes made to the Admin
Password.
D
User Password
Select the Enabled check box to require a password to open the operation window
on the computer.
The following items can be set.
Item Function
New Password Enter the new password when changing the password to
open the operation window. (The password can contain
up to 26 single-byte alphanumeric characters.)
Confirm Enter the same password as you entered in New
Password. If the passwords are not the same, an error
will be displayed.
Send Click this button to commit changes made to User
Password.
About Crestron RoomView®
121
To Next Page
Loading...
Need help?
General
