You can select the aspect mode according to the type of input signal, ratio
of height and width, and resolution to switch the
Aspect Ratio
g
of the
projected image. The aspect modes are listed below. The aspect modes that
can be set depend on the type of image that is being projected.
EB-Z8455WU/Z8450WU/Z8355W/Z8350W
Aspect mode Explanation
Normal
Projects to the full projection size retaining the aspect
ratio of the input image.
Auto
Projects in an appropriate aspect ratio based on
information from the signal being input.
16:9
Projects to the full projection size at an aspect ratio of
16:9.
16:9 (Up)
Projects to the full projection size at an aspect ratio of
16:9 on the top of the screen.
16:9 (Down)
Projects to the full projection size at an aspect ratio of
16:9 on the bottom of the screen.
Full
Projects at full size.
Zoom
Projects the input image enlarged to the full lateral
direction size as the aspect ratio remains. Parts that
extend beyond the projection size are not projected.
Native
Projects at the resolution of the input image size to the
center of the screen. This is ideal for projecting clear
images.
If the image resolution exceeds the panel resolution of
this projector (EB-Z8355W/Z8350W: 1280x800, EB-
Z8455WU/Z8450WU: 1920x1200), the edges of the
image are not projected.
EB-Z10005/Z10000/Z8150
Aspect mode Explanation
Normal
Projects to the full projection size retaining the aspect
ratio of the input image.
Aspect mode Explanation
Auto
Projects in an appropriate aspect ratio based on
information from the signal being input.
4:3
Projects to the full projection size at an aspect ratio of 4:3.
This is suitable for images at an aspect ratio of 5:4
(1280x1024, etc) at full projection size.
16:9
Projects at an aspect ratio of 16:9. This is suitable for
projecting to the full screen size of 16:9.
16:9 (Up)
Projects to the full projection size at an aspect ratio of
16:9 on the top of the screen.
16:9 (Down)
Projects to the full projection size at an aspect ratio of
16:9 on the bottom of the screen.
Native
Projects at the resolution of the input image size to the
center of the screen. This is ideal for projecting clear
images.
If the image resolution exceeds the panel resolution of
this projector (1024x768), the edges of the image are not
projected.
Procedure
Remote Control
The aspect mode name is displayed on the screen by pressing the button.
If you press the button while the aspect mode name is displayed on the
screen, it changes to the next aspect mode.
Changing the Aspect Ratio of the Projected Image
22
To Next Page
Loading...
Need help?
General
