Notes on Operating the Network Menu
Selecting from the top menu and sub menus, and changing of selected
items are the same as operations in the configuration menu.
When done, make sure you go to the Setup complete, and select one of
Yes, No, or Cancel. When you select Yes or No, you return to the
configuration menu.
Yes: Saves the settings and exits the Network menu.
No: Exits to the Network menu without saving the settings.
Cancel: Continues displaying the Network menu.
q
If the settings contain an invalid value, the settings may not take
effect, even after you select Yes.
Soft Keyboard Operations
The Network menu contains items that require input of alphanumerics
during setup. In this case, the following software keyboard is displayed. Use
the [
h] button on the remote control or [w/ ], [v/ ], [</ ], and
[
>/ ] on the projector to move the cursor to the desired key, and then
press the [Enter] button to enter the alphanumeric. Enter figures by holding
down the [Num] button on the remote control, and pressing the numeric
buttons. After inputting, press [Finish] on the keyboard to confirm your
input. Press [Cancel] on the keyboard to cancel your input.
• Each time the [CAPS] key is selected and the [Enter] button is pressed,
it switches between uppercase and lowercase letters.
• Each time the [SYM1/2] key is selected and the [Enter] button is
pressed, it switches the symbol keys in the section enclosed in the box.
Network Menu
61
To Next Page
Loading...
Need help?
General
