Settings for the image in the configuration menu can be registered in
memory, and can be used when needed. You can register up to ten types of
memory.
Available Settings
Setting items in the configuration menu that can be registered in memory
are listed below.
Top Menu Sub Menu
Image All setting items
Signal Progressive
Frame Interpolation
*1
Super-resolution
Noise Reduction
Mosquito NR
HDMI Video Range
SDI Video Range
*1
Scale
Overscan
Settings Power Consumption
*2
Extended Brightness Level
*2
Edge Blending
Multi-screen
*1 EB-Z8455WU/Z8450WU only
*2 EB-Z8455WU/Z8450WU/Z8355W/Z8350W/Z10005/Z10000 only
Saving/Loading/Erasing the Memory
Saving the memory
Use the following procedure to register the memory.
Procedure
A
During projection, press the [Menu] button on the remote
control or control panel, and select Settings - "Memory" from
the configuration menu.
s "Using the Configuration Menu"
p.47
B
Select "Save Memory", and then press the [Enter] button.
C
Select the memory name that you want to register the setting,
and then press the [Enter] button.
Current settings are registered in the memory.
Memory Function
44
To Next Page
Loading...
Need help?
General
