Switching the left and right image sizes
Procedure
A
Press the [Menu] button on the remote control or the control
panel during split screen projection.
B
Select "Screen Size" and press the [Enter] button.
C
Select the image size to display and then press the [Enter]
button.
D
Press the [Menu] button to end the setting procedure.
The projected images will appear as shown below after setting the screen
size.
Equal Larger Left
Larger Right
q
• You cannot enlarge both the left screen and right screen images at
the same time.
• When one image is enlarged, the other image is reduced.
• Depending on the video signals that are input, the images on the left
and right may not appear to be the same size even if Equal is
set.
Ending the split screen
Procedure
To end the split screen, press the [Esc] button on the remote control
or control panel.
The following steps can also be used to end the split screen.
• Press the [Split] button on the remote control.
• Select Exit Split Screen in the Split Screen Setup and then press the
[Enter] button.
Projecting Two Images Simultaneously (Split Screen)
31
To Next Page
Loading...
Need help?
General
