Lets you check the status of the image signals being projected and the status of the projector. Items that can be displayed vary depending on the image signal or
input source being projected as shown in the following screen shots.
RGB Signal/Component Video
g
Signal Composite video
g
Signal/S-Video
g
Signal LAN
Sub Menu Function
Lamp Hours
You can display the cumulative lamp operating time
*1*2
.
When it reaches the lamp warning time, the characters are displayed in yellow.
Lamp Status
The following icons show the status of the lamps.
: Lighted : Disable
When
is displayed, the lamp is not operating normally. See "Reading the Indicators". s p.83
Source
You can display the Source name for the connected equipment currently being projected.
Input Signal
You can display the content of Input Signal set in the Signal menu according to the Source.
Resolution
You can display the Resolution.
Video Signal
You can display the content of Video Signal set in the Signal menu.
Refresh Rate
You can display the
Refresh Rate
g
.
Sync Info
You can display the image signal information.
This information may be needed if service is required.
Status
This is information about errors that have occurred on the projector.
This information may be needed if service is required.
Serial Number
Displays the projector's serial number.
Info Menu (Display Only)
77
To Next Page
Loading...
Need help?
General
