There are two methods for setting WPS
g
.
• Push Button Method
SSID and security are set automatically when the [Enter] button is pressed
on the projector's control panel and the dedicated button on the access
point equipment. This method is recommended when the projector and
access point are close together.
• PIN Code Method
SSID and security are set automatically by inputting an 8-digit code that
was assigned to the projector from the computer to the access point in
advance. Make connection settings between the computer and the access
point in advance. For details on how to make this connection, refer to the
manual provided with the access point. This method is recommended
when the projector is mounted on the ceiling.
q
Refer to the documentation for the access point device and to the
following section when using any connection method other than WPS.
s
"Wireless LAN Menu" p.63
Connection Setup Method
Procedure
A
During projection, press the [Menu] button and select
"Network" - "Network Configuration" from the configuration
menu.
The Network Configuration screen is displayed.
B
From "Wireless LAN" select "To Setup Wizard".
The following screen is displayed.
Making a WPS (Wi-Fi Protected Setup) Connection with a Wireless LAN Access Point
125
To Next Page
Loading...
Need help?
General
