Cut-Sheet Feeders
3.
Pull the paper-set levers forward until the paper guides retract
and lock open.
4.
Take a stack of paper and fan it. Next, tap the side and bottom of
the paper on a flat surface to even up the stack.
0
t
CAUTION: Do not use multi-part forms, carbon paper, or
l
labels in the cut-sheet feeder.
5.
Insert up to 150 sheets of paper or 25 plain bond envelopes, or 30
airmail envelopes along the left paper guide.
6.
Adjust the position of the right paper guide so that it matches
your paper’s width and lock it in place. Make sure the position
of the guide allows the paper to move up and down freely.
Using the Printer Options
4-7
To Next Page
Loading...
