Maintenance 6. Alarm
146 RC700 / RC700-A Rev.23
6.2.3 How to Edit the Maintenance Information
The configured maintenance information can be edited in the EPSON RC+ 7.0 Ver.7.2.x
or later.
(1) Select the EPSON RC+ 7.0 menu-[Tools]-[Maintenance] to display the [Controller
Tools] dialog box.
(2) To edit the maintenance information, display the [Maintenance] dialog box.
(3) Select “General” or specify the axis from the tree to display information of the target
parts.
(4) Select the alarm to be changed and click the <Change> button.
(5) Display the [Change Alarm] dialog box and enter any of the followings.
Purchase or replacement date of the battery
Date of grease up
Purchase or replacement date of the timing belt
Purchase or replacement date of the motor
Purchase or replacement date of the reduction gear unit
Purchase or replacement date of the ball screw spline unit
(6) Click the <OK> button and change the specified alarm information.
The offset can be set for the consumption rate of already installed parts.
Follow the steps below to calculate a rough offset setting value.
1. Measure the usable months for the past operation by HealthRBAnalysis.
2. Confirm the past Motor ON time in the controller status viewer.
3. Calculate a rough offset value with the following formula.
Offset=100
24×30.4375× Usable months
For details, refer to the following manual.
EPSON RC+ 7.0 SPEL+ Language Reference
To Next Page
Loading...
Need help?
General
