Epson RC700-A User Manual

Maintenance 7. Maintenance Parts Replacement Procedures
152 RC700 / RC700-A Rev.23
7.3 Battery
CAUTION
■
Use
meticulous care when handling the lithium battery. Improper handling of the
lithium battery as mentioned below is
extremely hazardous, may result in heat
generation,
leakage, explosion, or inflammation, and may cause serious safety
problems.
・Battery Charge
・
Disassembly
・
Incorrect Installation
・
Exposing to Fire
・Forced Discharge
・Deformation by Pressure
・
Short-circuit (Polarity; Positive/Negative)
・
Heating (85°C or more)
・
Soldering the terminal of the lithium battery directly
■
Be sure to use the battery supplied as maintenance part from EPSON (Refer to
10. Maintenance Parts List).
■
When disposing of the battery, consult with the professional disposal services or
comply with the local regulation.
Spent battery or not, make sure the battery terminal is insulated. If the terminal
contacts with the other metals, it may short and result in heat generation,
leakage, explosion, or inflammation.
T
urn ON the Controller for approximately one minute before replacing the battery.
Finish
the replacement within 10 minutes to prevent data loss.
Battery
Remov
al
(1)
Backup the Controller data.
Refer to
Maintenance 4. Backup and Restore.
(2)
Turn OFF the Controller.
(3)
Disconnect the power
plug.
(4)
Remove
the battery bracket. (Mounting screw ×2)
RC700
RC700-
A
(5)
Pull out the battery
bracket.
(6)
Disconnect the battery cable.
(7)
Remove
the battery straight upward.

NOTE

Epson RC700-A Specifications

General

Brand	Epson
Model	RC700-A
Category	Controller
Language	English