Epson RC700-A User Manual

Setup & Operation 14. Option Slots
108 RC700 / RC700-A Rev.23
14.8.2 Board Settings (EUROMAP67 Board)
Configure DIP-Switch (SW1) to enable the robot controller to recognize the
EUROMAP67 board.
Board Appearance
Switch setting: Setup the DSW1
SW1
1
st
board
2
nd
board
14.8.3 Installation (EUROMAP67 Board)
(1) Turn OFF the Controller.
(2) Disconnect the power plug.
(3) Remove the Top Panel. (Mounting screw ×6)
(4) Insert the EUROMAP67 board into either slots 1, 2 or 3.
(Slot 4 cannot be used.)
(5) Use four screws to fix the EUROMAP67 board in place.
First, temporarily fasten the four screws in place. Next, fully tighten screws located
diagonally opposite each other.
Take care not to damage the thread holes when doing so.

Epson RC700-A Specifications

General

Brand	Epson
Model	RC700-A
Category	Controller
Language	English