Epson RC700-A - Setup from Control Device

Safety 4. Operation Mode (TEACH/AUTO/TEST)
RC700 / RC700-A Rev.23 39
4.4.3 Setup from Control Device
Set the control device from EPSON RC+.
(1) Select EPSON RC+ menu-[Setup]-[System Configuration] to display the [System
Configuration] dialog.
(2)
(5)
(3)
(4)
(2) Select [Controller]-[Configuration].
(3) Select [Setup Controller]-[Control Device] to select the control device from the
following two types.
- PC
- Remote (I/O)
(4) Click the <Apply> button.
(5) Click the <Close> button.