Epson RC700-A User Manual

Maintenance 9. Troubleshooting
RC700 / RC700-A Rev.23 297
No.
Message
Remedy
Note 1
Note 2
10000
Command aborted by user
-
10001
Command timeout.
-
10002
Bad point file line syntax
-
10003
Project could not be built.
-
10004
Cannot initialize Spel class instance.
-
10005
Cannot initialize parser.
-
10006
Cannot initialize wbproxy.
-
10007 Project does not exist.
Check whether the project
name and the path are correct.
10008
No project specified.
Specify the project.
10009 Cannot open file.
Check whether the project
name and the path are correct.
10010
Cannot create file.
-
10011 File not found
Check whether the project
name and the path are correct.
10013
Cannot execute LoadPoints with Robot
Manager open.
Close the robot manager and
execute.
10014
Project cannot be locked. It is being
used by another session.
Terminate other applications.
10015 Project could not be synchronized.
-
10016 Drive not ready
Check whether the drive
designation is correct.
10017
Invalid IP address
Check the IP address.
10018
Invalid IP mask
Check the IP mask.
10019
Invalid IP gateway
Check the IP gateway.
10020
IP address or gateway cannot be the
subnet address.
Check the IP address.
10021
IP address or gateway cannot be the
broadcast address.
Check the IP address.
10022
Invalid DNS address
Check the DNS.
10023
Commands cannot be executed
because the project build is not
complete.
Execute after the project build is
completed.
10024
Invalid task name.
Check the task name.
10100 Command already in cycle. -
10101 Command aborted by user. Execute ResetAbort.
10102
Invalid server instance.
Specify the correct instance.
10103 Invalid CommandTask value.
Specify the correct task
number.
10104
Cannot change ServerInstance after
initialized.
Set ServerInstance before
initialization.
10501 Connection aborted. -
10502 Cannot connect with the controller. -
10503
Controller firmware is not compatible
with this version of RC+.
Upgrade the RC+ version.
10504
USB connection of this system is
reserved for the RC620 Controller and
cannot be used for RC+7.0.
Install the RC+7.0 to another
computer.
10505
The specified connection does not
exist.
Check the connection number.
10600 Frame grabber driver not installed. Install the driver.

Epson RC700-A Specifications

General

Brand	Epson
Model	RC700-A
Category	Controller
Language	English