Epson RC90 User Manual

2. Installation
RC700 / RC90 Option Fieldbus I/O Rev.14 97
Master Mode
1. Check that the PROFIBUS-DP master board manufactured by molex is connected to
the PROFIBUS-DP network.
2. Start the “applicomIO Console” application.
3. The [applicomIOR console] dialog box appears. Register the device information
(GSD file) that is necessary for the network setup.
(4)
(5)
(6)
4. Select [Protocol].
5. Select the [Equipment Library] tab.
6. Click <Add>.

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English