Epson SC-F9200 series - Page 197

SC-F9200 Series Revision B
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 197
SE Group Confidential (Related Staff Only)
Figure 3-140. Removing the Ink Tube Holder
Figure 3-141. Ink Tube Holder
11. Remove the four screws, and separate the Upper Joint and Lower Joint.
B) Silver M3x10 screw: 4 pcs
Figure 3-142. Removing the Ink Tubes
A
- Rear side -
Ink Tube Holder
C A U T I O N
When the joint is removed in the next step, ink may drip off from
the tube. Prepare a waste cloth or the like in advance and be careful
not to contaminate the surroundings.
 Attach the Joint as shown in the figure below.
B
B
Upper Joint
Ink Tube
B
B
Upper Joint
Ink Holder 1 (Home)
Ink Holder 2 (Full)
Red mark
Red mark