B
Install the spacer into the gray flange (fixed part).
Push the spacer until the holes in the spacer
and the flange line up exactly.
Removing the spacer
A
Remove the black flange from the spindle.
B
Remove the spacer.
Hold the outer edge of the spacer and pull it
straight off.
Placing roll paper on the spindle
Follow the steps below to set roll paper on the spindle
supplied with the printer.
A
Remove the black flange from the spindle.
B
Insert the spindle into the roll paper.
Place the roll paper on a flat surface where the
end of the roll paper is hanging down towards
you, and insert the spindle from the right.
C
Push the roll paper so that there is no space
between it and the flange fixed to the spindle.
D
Push the black flange so that there is no space
between the flange and the roll paper.
Loading roll paper
Follow the steps below to load roll paper on the printer.
c
Important:
Insert the paper just before printing. If the paper is
left in the printer, the pressure roller may leave a
mark on the surface of the paper.
A
Make sure the printer is on.
SC-P5000 Series User's Guide
Basic Operations
33
To Next Page
Loading...
Need help?
General
