EPSON Stylus CX3500/CX3600/CX3650/CX4500/CX4600 Revision A
TROUBLESHOOTING Troubleshooting 87
Table 3-5. Check point for the error before the initial ink charge according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
•Power on
•Inside HP
The SPC does not perform the initial ink
charge and an error is indicated with
LEDs and STM3.
Ink Cartridge
1. Check if the Ink Cartridge can be used by installing it to
other SPC.
1. Replace the Ink Cartridge with a brand-new
one.
Main Board
1. Check if an incorrect data is not stored into the address of
the EEPROM on the Main Board.
1. Set the proper destination by using
Adjustment Program.
•Power on
•Anywhere
The SPC does not perform the ink
replacement CL and an error is indicated
with LEDs and STM3.
Ink Cartridge
1. Check if the Ink Cartridge can be used by installing it to
other SPC.
1. Replace the Ink Cartridge with a brand-new
one.
The SPC does not perform the printing
operation and an error is indicated with
LEDs and STM3.
Ink Cartridge
1. Check if the ink is remaining in the Ink Cartridge. 1. Replace the Ink Cartridge with a brand-new
one.
2. Check if the Ink Cartridge can be used by installing it to
other SPC.
2. Replace the Ink Cartridge with a brand-new
one.