Epson Stylus CX3500 - Overview; Required Adjustment

EPSON Stylus CX3500/CX3600/CX3650/CX4500/CX4600 Revision A
ADJUSTMENT Overview 162
5.1 Overview
This section describes the procedure for adjustments required when the printer is
disassembled and assembled for repair or service.
5.1.1 Required Adjustment
If you remove or replace the specific part in your service/repair, you have to perform
the appropriate adjustment as listed Table 5-1 below.
In this printer, it is necessary to perform appropriate adjustment in order to maintain
consistent printing function and quality, eliminate differences of each printer
mechanism’s characteristics. Therefore, in case that the combination between the
printer mechanism and the Main Board changes or the Print Head is replaced during
the repair service, you must input the correct adjustment value into the EEPROM on
the Main Board by using the Adjustment program.
Note : Symbol explanation
The numbers in the circle shows the required adjustment order.
“NA”: Not applicable
Table 5-1. Required Adjustment
CHECK
PO INT
In case that any parts are removed and assembled on the repair
product while running the Adjustment program, make sure to
turn off the printer.
Performance
Priority
1 2 3 4 5 6 7 8 9 10 11 12 13 14
EEPROM
Data Copy
Waste ink
pad counter
Destination
setting
Initialize PF
deterioration
offset
Disenable
PF
deterioration
offset
Ink charge
Input Head
ID
Input PF
roller
manufacture
code*
3
Top margin
adjustment
Head
angular
adjustment
Bi-D
adjustment
PW
adjustment
First dot
position
adjustment
CR motor
heat
protection
control
Printer Mechanism
replacement
NA NA NA NA NA NA NA NA NA NA
ASF Unit removal NA NA NA NA NA NA NA NA NA NA NA NA
ASF Unit
replacement
NA NA NA NA NA NA NA NA NA NA NA NA
CR Motor removal NA NA NA NA NA NA NA NA NA NA NA
CR Motor
replacement
NA NA NA NA NA NA NA NA NA NA
Paper Guide Upper
Unit removal
NA NA NA NA NA NA NA NA NA NA NA NA NA
Paper Guide Upper
Unit replacement
NA NA NA NA NA NA NA NA NA NA NA NA NA
Front Frame removal NA NA NA NA NA NA NA NA NA NA NA NA
Front Frame
replacement
NA NA NA NA NA NA NA NA NA NA NA NA
Print Head removal NA NA NA NA NA NA NA NA NA NA
Print Head
replacement
NA NA NA NA NA NA NA NA
Adjustment
Item
Replaced part
1 2 3 4
1 2
1 2
1 2 3
1 2 3 4
1
1
1 2
1 2
1 2 3 4
1 2 3 4 5 6