Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series Revision I
Stylus Photo R2000/R2000s Features 178
Table 8-5. Communication Speed for 802.11n
*
1
*
2
MCS : Modulation and Coding Scheme GI : Guard Interval
Note *1: After the decimal point is displayed by the 0.5Mbps.Number in parentheses is
defined value of 802.11n standard.
*2: For regulation of Radio Law, if Bandwidth is fixed to 20MHz by exporting area,
maximum of Communication Speed is restricted to upper limit of 20MHz.
Switching Wired/Wireless LAN
This printer can be connect to the network via either Wired LAN or Wireless LAN
connection only.
Enabling/disabling the Wireless LAN can be made from the Control Panel. When the
Wireless LAN is enabled, it gets priority over the Wired LAN regardless of whether
the LAN Cable is connected. The default Wireless LAN setting is “Disabled”.
Note * : No service via network is available without connecting the LAN Cable (because
network communication is not established.) except printing a status sheet or the like.
MCS Index
Bandwidth = 20MHz Bandwidth= 40MHz
GI = 800ns GI = 400ns GI = 800ns GI = 400ns
0 6.5 7 (7.2) 13.5 15
1 13 14 (14.4) 27 30
2 19.5 21.5 (21.7) 40.5 45
3 26 28.5 (28.9) 54 60
4 39 43 (43.3) 81 90
5 52 57.5 (57.8) 108 120
6 58.5 65 121.5 135
7 65 72 (72.2) 135 150
Table 8-6. Wireless LAN Setting from the Control Panel
Setting from Control Panel
LAN Cable Connection State
Connected Disconnected
Wireless LAN Disabled
(Default)
Wired LAN ---*
Enabled Wireless LAN Wireless LAN
To Next Page
Loading...
Need help?
General