Epson Stylus Pro 9900 - Page 128

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
TROUBLE SHOOTING Remedies for Error Messages related to SpectroProofer/Auto Take-up Reel 128
Confidential
45
Take-up
system
Lock error
Detects that it is being driven at an
irregularly slower speed than the
specified value.
Encoder cable is damaged. Replace the cable.
Yes
Motor cable is damaged.
Replace the Auto Take-up Motor.
(See P.320)
Slack Sensor is broken.
Auto Take-up Motor is broken.
20
CR Driving time-out error
Detects that the driving period is
irregularly long.
Firmware becomes out of control.
Replace the Main Board Assy.
(See P.332)
Yes
80
---
ILS Calibration error
Color measurement was not
performed correctly.
 Abnormality of White Plate holder
 Abnormality of il Calibrator
Check if the White Plate holder is
attached, and the plate is dirty or
not. If it is dirty, clean it.
Yes
Check if there is dust or dirt
attached on the lens on the
calibrator. If there is any, clean it.
Check if the lamp of the calibrator
burned out or not.
Replace the calibrator and the
White Plate.
Error
No.
Section Error Name Status Cause Remedy/Check Point Program Check