Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 292
Confidential
4.4.6.8 Ink Holder Board Assy R
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Unlock the Carriage Unit and move it to the center. (p201)
6. Remove the Ink System Unit. (p266)
7. Pull off the Pressure Tube from the main body.
8. Release the Pressure Tube from the guide of the Board Cover.
9. Pull out the Pressure Tube from the hole of the Board Cover.
10. Disengage the two hooks, and remove the Board Cover.
Figure 4-144.
Removing the
Board Cover
C H E C K
P O I N T
The next step is not necessary when the Ink Cartridge Holder R is
already removed.
Make sure to connect the Pressure Tube.
Board Cover
Pressure Tube
Guide
Hole
Hooks
To Next Page
Loading...
