Epson Stylus Pro 9900 - Tests; Network Communication Check; Suction Fan Operation Check

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Tests 428
Confidential
5.9 Tests
5.9.1 Network Communication Check
Use this to check if the printer can communicate with the computer via a network.
PROCEDURE
1. Turn the printer ON.
2. Start the Service Program and select Check Network Communication menu.
3. Enter the IP address of the printer, and press [Run].
When the network communication is available, a status sheet is printed
automatically.
4. Click [Finish].
Figure 5-85. [Check Network Communication] Screen
5.9.2 Suction Fan Operation Check
This allows you to check if Suction Fan is operated correctly.
PROCEDURE
1. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu ] + [Paper Feed ] + [OK]
simultaneously.
2. Select SELF TESTING
→ Test → FAN.
3. Select the fan you want to operate and press [Menu], the Suction Fan starts
operating.
4. If you want to stop the fan, press [Pause/Reset].
NOTE: If you want to change the suction power, change the value from Paper
(Duty).