Epson Stylus Pro 9900 - Front Cover (Middle)

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 213
Confidential
4.4.2.9 Front Cover (Middle)
1. Open the Front Cover (Middle).
2. Remove the 12 screws that secure the Front Cover (Middle), and remove the Front
Cover (Middle).
A) Black, Phillips, Bind P-tite M4x10: 12 pieces
Figure 4-25. Removing the Front Cover (Middle)
C A U T I O N
In the next step, the cover will drop immediately after removing the
last screw. Therefore, make sure to hold the cover when removing
the last few screws.
C A U T I O N
When replacing the Front Cover with a new one, check if washers
are installed to the screw holes (x4) as shown below. If installed,
transfer them to the new Front Cover.
(Epson Stylus Pro 9700/9710/9900/9910 only.)
A
Front Cover (Middle)