Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
MAINTENANCE Setting Up/Storing the Printer 447
Confidential
6.2 Setting Up/Storing the Printer
6.2.1 Setting Up
Make sure to open up the following installation room for the printer so as to maintain
appropriate operation and usability.
Figure 6-1. Installation Room Requirement
6.2.2 Storing the Printer and Cleaning the Ink Path
When storing the printer, make sure to leave the ink cartridges installed and place it on
a horizontal surface, and also inform the user on the following cautions.
When storing the printer for a long time
Print regularly to prevent clogging of the nozzles.
Turn on the printer at least once a month, and leave it on for a few minutes.
Leave all the ink cartridges installed in the slots.
Remove the paper.
If it is not used for more than six months
Make sure to print a nozzle check pattern and check for clogging of the printhead.
If any clogging can be seen, carry out head cleaning.
If it is not improved after performing head cleaning three times, carry out Power
cleaning.
C A U T I O N
When installing the Epson Film Basket to Epson Stylus Pro
WT7900/WT7910, more space is needed in front of the printer.
C H E C K
P O I N T
When activating “Auto Nozzle Check” in the panel settings, the
printer will carry out head cleaning automatically.
After performing the head cleaning a few times, try turning off
the printer and leaving it overnight or longer, so that the ink
may dissolve and the clogging might be improved.
To Next Page
Loading...
