Epson Stylus Pro 9900 - Absorber Position Check

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Head Related Adjustments 398
Confidential
5.4.9 Absorber Position Check
This allows you to adjust the print position to the absorber (waste ink pad) for
borderless printing. (This is a check only)
NOTE: This adjustment is not applied to Epson Stylus Pro WT7900/WT7910.
PAPER USED
 Size:
 Epson Stylus Pro 9700/9710/9900/9910/9890/9908: 44 inches
 Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/7890/7908:24 inches
 Type: Premium Glossy Photo Paper (250)
PROCEDURE
1. Turn the printer ON.
2. Press [Menu ] and enter the panel setting mode.
3. Select PRINTER SETUP
→ PAPER SIZE CHECK and change the setting to
OFF.
4. Press [Paper Source ] to change the setting of cutting roll paper to OFF.
5. Turn the printer OFF.
6. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu ] + [Paper Feed ] + [OK]
simultaneously.
7. Select SELF TESTING
→ Mecha Adjustment → Pad Position.
8. Press [OK] while [Enter] Printing is displayed.
The adjustment pattern will be printed.
9. Press [Paper Cut] and cut off the adjustment pattern.
10. Open the Front Cover (Middle).
11. See Figure 5-59 and check if the standard line for the Waste Ink Pad for the
borderless printing is within the OK range.
 : 12 points
 Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/7890/7908:8 points
12. Close the Front Cover (Middle), and turn the printer OFF.
Figure 5-58. Adjustment pattern
Figure 5-59. Adjustment pattern (zoom)
C A U T I O N
This adjustment is performed on the factory. It cannot be adjusted
on the field.
The opposite side Home position
OKNG NG OKNG NG OKNG NG OKNG NG
Standard line Standard line Standard line Standard line
Checks for (1) Checks for (2) or left
OK NG OK NG