Epson Stylus Pro 9900 - Cut Position Adjustment

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Other Adjustment 425
Confidential
5.7.7 Cut Position Adjustment
Adjusts the paper position cut by the Auto Cutter.
PAPER USED
 Size
 Epson Stylus Pro 9700/9710/9900/9910/9890/9908: 44 inches
 Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/7890/7908:24 inches
 Type: Premium Glossy Photo Paper (250)
STANDARD VALUE
 15 ± 0.3 mm
PROCEDURE
1. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu ] + [Paper Feed ] + [OK]
simultaneously.
2. Select SELF TESTING
→ Mecha Adjustment → Cutter → Printing.
3. Press [OK] while [Enter] Print is displayed.
The adjustment pattern will be printed.
4. Measure the distances of Home, Center and Full as shown in Figure 5-83.
 Within the standard value: Turn the printer OFF and finish the adjustment.
 Out of the range: Go to Step 5.
5. Select Input, and enter the maximum value and the minimum value in order
among the values measured in Step 4.
 Maximum value: Select Cut Position Home and enter the value.
 Minimum value: Select Cut Position Full and enter the value.
6. Return to Step 2.
Figure 5-83. Adjustment Pattern
Paper
feeding
direction
Center HomeFull