Epson Stylus Pro 9900 - Clear Counters

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Clear Counters 427
Confidential
5.8 Clear Counters
Whenever the parts/units which have life counter are replaced, the corresponding life
counter must be reset. This is important to replace those parts/units at the correct
timing.
PROCEDURE
1. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu ] + [Paper Feed ] + [OK]
simultaneously.
2. Start the Service Program and select a target Counter Reset menu.
3. Click [Run] to reset the counter.
4. Click [Finish].
Figure 5-84. [Clear Counter] Screen
Table 5-3. Clear Counter Menu List
Replaced Part/Unit Menu Name
Pro
7900/
7910/
9900/
9910
Pro
7700/
7710/
9700/
9710
Pro
WT7900/
WT7910
Printer
INK TUBE L/R When replacing Ink tube
√√√
Wiper Cleaner Assy When replacing Wiper
√√√
INK SYSTEM UNIT
(PUMP MOTOR)
When replacing Wiper
√√√
When replacing Pump motor
√√√
PRESSURIZING UNIT
When replacing Pressurizing
motor
√√√
INK SELECT MOTOR
When replacing Ink select
motor
√ – √
INK HOLDER L/R When replacing Cartridge
holder (Ink Pad)
√√√
PF MOTOR When replacing PF motor
√√√
CR MOTOR When replacing CR motor
√√√
PRINTHEAD When replacing Printhead
√√√
AID BOARD When replacing AID board
√√√
SpectroProofer
Carriage Motor When replacing CR Motor
√ – √
Paper Pressing Motor
When replacing Paper Pressing
Motor
√ – √
Cooling Fan 1/2 When replacing Fans
√ – √
C A U T I O N
 Take care when using All Counter Clear in Counter Reset. This
function clears all the counters such as the total operating time
or the like including the parts to be replaced mentioned above.
 Make sure to perform a Clear Counter for the SpectroProofer
after confirming that the SpectroProofer is in the ready state
(when the LED is on). If it is performed in the OFF or sleep
state, the counter is not reset correctly.
 Clear Counters can be done in Serviceman Mode though, make
sure to perform this function using the Service Program.