Epson Stylus Pro 9900 - Cutter Unit

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 257
Confidential
4.4.5.6 Cutter Unit
1. Remove the IC Cover (L/R) and the IC Shaft Cover (L/R). (p206)
2. Remove the Maintenance Tank (L/R). (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Control Panel. (p203)
4. Remove the Right Cover. (p209)
5. Remove the Left Cover. (p211)
6. Unlock the Carriage Unit. (p201)
7. Open the Front Cover (Middle).
8. Remove the screw that secures the Ink Tube Guide, and remove the Ink Tube
Guide.
A) Silver, Phillips, Bind machine screw M3x8: one piece
9. Remove the seven EJ Roller Units from the Cutter Unit.
10. Push down the handle, and remove the Cutter Cover.
Figure 4-93. Removing the Ink Tube Guide
Figure 4-94. Removing the EJ Roller Unit
A
Front Cover (Middle)
Ink Tube Guide
Cutter Unit
Mid-Front Cover
EJ Roller Unit
Handle
Cutter Cover
EJ Roller Unit