Epson Stylus Pro 9900 - Ink Holder Board Assy L

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 290
Confidential
4.4.6.7 Ink Holder Board Assy L
1. Remove the IC Cover L and the IC Shaft Cover L. (p206)
2. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p211)
4. Pull off the Pressure Tube from the main body.
5. Release the Pressure Tube from the guide of the Board Cover.
6. Pull out the Pressure Tube from the hole of the Board Cover.
7. Disengage the two hooks, and remove the Board Cover.
Figure 4-142. Removing the Board Cover
Make sure to connect the Pressure Tube.
Board Cover
Pressure Tube
Guide
Hole
Hooks