Epson Stylus Pro 9900 - Page 291

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 291
Confidential
8. Disconnect the connectors (CN408, CN409) and FFC (CN400) from the Ink
Holder Board Assy L.
9. Remove the five screws that secure the plate.
A) Silver, Phillips, Bind P-tite M3x10: five pieces
10. Remove the plate.
11. Remove the ten screws that secure the Ink Holder Board Assy L.
B) Silver, Phillips, Bind S-tite M3x6: two pieces
C) Silver, Phillips, Bind P-tite M3x10: eight pieces
12. Remove the Ink Holder Board Assy L.
Figure 4-143. Removing the Ink Holder Board Assy L
C H E C K
P O I N T
Use a stubby driver or a ratchet driver for the following procedure.
If you do not have such a driver, remove the Ink Cartridge Holder
L before disassembly. (see p284)
Be careful not to damage the CSIC terminal when removing/
installing the Ink Holder Board Assy L.
- Back of Ink Holder Board -
Terminal
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing the Ink Holder Board Assy L.
<Adjustment Item>
1. Ink Holder Adjustment
CN408
CN409
A
B
C
Plate
Ink Holder Board Assy L
CN400