Epson Stylus Pro 9900 - Page 289

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 289
Confidential
13. Remove the six screws that secure the Ink Cartridge Holder Mounting Plate, and
remove the Ink Cartridge Holder Mounting Plate.
B) Silver, Phillips, Round Washer Head S-tite M4x8: four pieces
C) Silver, Phillips, Round Washer Head S-tite M3x6: two pieces
14. Remove the four screws that secure the Ink Cartridge Holder L.
D) Silver, Phillips, Round Washer Head S-tite M4x6: four pieces
15. Remove the Ink Cartridge Holder L.
Figure 4-141. Removing the Ink Cartridge Holder L
Secure the Ink Cartridge Holder L together with the grounding
wire using the same screw shown in the figure.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing the Ink Cartridge Holder L.
<Adjustment Item>
1. Counter Clear (IH Absorber)
2. Ink Holder Adjustment
3. Air Leak Check for Ink Supply Sys.
C
B
- Left side -
Ink Cartridge Holder Mounting Plate
Ink Cartridge Holder L
Screw
together
D