Epson Stylus Pro 9900 - Page 293

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 293
Confidential
11. Disconnect the FFC (CN400) from the Ink Holder Board Assy and release the FFC
from the clamp.
12. Disconnect the connectors (CN408, CN409) from the Ink Holder Board Assy R.
13. Remove the five screws that secure the plate.
A) Silver, Phillips, Bind P-tite M3x10: five pieces
14. Remove the plate.
15. Remove the ten screws that secure the Ink Holder Board Assy R.
B) Silver, Phillips, Bind S-tite M3x6: two pieces
C) Silver, Phillips, Bind P-tite M3x10: eight pieces
16. Remove the Ink Holder Board Assy R.
Figure 4-145. Releasing the FFC
Figure 4-146. Removing the Ink Holder Board Assy R
Be careful not to damage the CSIC terminal when removing/
installing the Ink Holder Board Assy R.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing the Ink Holder Board Assy R.
<Adjustment Item>
1. Ink Holder Adjustment
- Back of Ink Holder Board -
Terminal
Clamp
CN400
CN408
CN409
A
B
C
Plate
Ink Holder Board Assy R