Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
TROUBLE SHOOTING Remedies for Print Quality Troubles 154
Confidential
3.7.2.3 Troubleshooting when using Epson Stylus Pro WT7900/WT7910
Troubleshooting specific to Epson Stylus Pro WT7900/WT7910
Symptom Occurrence condition Cause
Remedy/Points to be checked
Auto cut cannot be made. When cutting it shorter than
420 mm
Minimum cutting length of the CPF by [Auto cut] is 420 mm. When
[Auto cut] is set for a medium with strong curl other than CPF, after
ejected the medium may be curled up and damage the print surface.
Cut the media manually when cutting 420 mm or shorter.
A cut is not made
immediately.
When [Manual cut] for the
CPF is selected
When [Manual cut] is set, the cut function pauses for two seconds after
the Paper Cut button is pressed so that the user can hold the cut paper
by hand after the paper is fed.
(This is to protect the print surface of the CPF/CCF from scratches
caused in the paper basket when the CPF/CCF curls up after being cut.)
Select [Auto cut] when making an immediate cut after
printing.
Release Film is hard to peel. When the Release Film sticks
strongly to the CPF and is hard
to peel
The Release Film is strongly attached to the CPF so as to prevent
rubbing or a jam from occurring if the film is peeled off during the CPF
feed.
If the Release Film is hard to peel, attach some scotch tape
and such to the edge of the Release Film to make peeling
easier and hold it when peeling the film.
When the media is laminated Remove the Release Film before laminating the media.
Print surface
Release Film
Scotch tape
To Next Page
Loading...
