Epson Stylus Pro 9900 - Page 235

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 235
Confidential
4.4.3.5 Sub Board Assy; C
1. Remove the IC Cover L and the IC Shaft Cover L. (p206)
2. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p209)
4. Disconnect all the cables and FFC on the Sub Board Assy; C.
5. Remove the three screws that secure the Sub Board Assy; C, and remove the Sub
Board Assy; C.
A) Silver, Phillips, Bind machine screw M3x6: four pieces
Connector assignment:
Figure 4-56. Connector locations
Figure 4-57. Removing the Sub Board Assy; C
Connector No. Color Destination
CN300
(FFC) Main Board Assy (CN300)
CN301
White Main Board Assy (CN301)
CN302
(FFC) PF Encoder Sensor
CN303
White PF Motor
CN304
White CR Motor
CN305
(FFC)
Maintenance Tank (L) (Epson Stylus Pro 9700/9710/9900/
9910/9890/9908 only)
CN307
White Cutter Sensor
CN309
Red Cutter Unit
CN310
White Roller Release HP Sensor
CN311
Red Cutter Unit
CN302 CN307 CN303
CN309
CN304
CN305
CN311
CN310
CN300 CN301
A
- Left side -
Sub Board Assy; C