Epson Stylus Pro 9900 - Page 243

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 243
Confidential
4.4.4.6 APG Motor
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Unlock the Carriage Unit and move it to the center. (p201)
6. Remove the screw that secures the APG Motor Cover, and remove the APG Motor
Cover.
A) Silver, Phillips, Bind S-tite with S.W & P.W. M3x8: one piece
7. Remove the two screws that secure the APG Motor, and remove the APG Motor.
B) Silver, Phillips, Pan S-tite with S.W & P.W. M3x6: two pieces
8. Disconnect the connector from the APG Motor.
Figure 4-69. Removing the APG Motor (1)
Figure 4-70. Removing the APG Motor (2)
C H E C K
P O I N T
When having difficulty in removing the screw in the next step, first
remove the plate B shown in
Figure 4-72. (p244)
A
APG Motor
APG Motor Cover
Connector
APG Motor
B