Epson Stylus Pro 9900 - Page 262

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 262
Confidential
3. Release the two each hooks that secure the EJ Rollers, and remove the EJ Rollers.
4. Disconnect the relay connector.
5. Release the harness from the clamp.
6. Remove the three screws that secure the Suction Fan.
B) Silver, Phillips, Round Washer Head P-tite M3x12: three pieces
7. Remove the Suction Fan.
Figure 4-101. Removing the Suction Fan
C A U T I O N
Since the hooks of the EJ Roller are fragile, do not apply excessive
force to them in the next step.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing or removing the Suction Fan.
<Adjustment Item>
1. Suction Fan Operation Check
Clamp
B
Hook
Relay Connector
Suction Fan
EJ Rollers