Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 301
Confidential
DISASSEMBLING PROCEDURE
1. Remove the Control Panel. (p203)
2. Remove the IC Cover (L/R) and the IC Shaft Cover (L/R). (p206)
3. Remove the Maintenance Tank (L/R). (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
4. Remove the Right Cover. (p209)
5. Remove the Left Cover. (p209)
6. Remove the Top Cover. (p214)
7. Unlock the Carriage Unit and move it to the center. (p201)
8. Disengage the four hooks on the bottom, and remove the CR Belt Cover.
9. Disconnect the connector (CN116, CN118) and FFC (CN105, CN106) on the Sub
Board Assy.
Figure 4-154. Removing the CR Belt Cover
Figure 4-155. Disconnecting the connectors
Hook
CR Belt Cover
Sub Board Assy
CN118
CN116
CN106
CN105
To Next Page
Loading...
