Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 303
Confidential
13. Slide the two Ink Tube Stoppers in the directions of the arrow to remove them.
14. Remove the two screws that secure the Ink Tube L, and remove the Ink Tube L
from the Ink Selector.
B) Silver, Phillips, Bind machine screw M2x16 (bit: No.1): 2 pieces
15. Remove the two screws that secure the Ink Tube R, and remove the Ink Tube R
from the Ink Selector.
B) Silver, Phillips, Bind machine screw M2x16 (bit: No.1): 2 pieces
Figure 4-158. Removing the Ink Tube Stopper
Figure 4-159. Removing the Ink Tube L and R
Use a torque driver with the torque given below when
tightening the screws securing the Ink Tube.
3±0.5kgf⋅cm
Make sure to install the SEAL RUBBER, JOINT, ASP. The
SEAL RUBBER, JOINT, ASP (1518317) is not included in the
Ink Cartridge Holder and the Ink Tube; therefore, re-use the
originally installed one. Make sure to confirm there is no
damage or no foreign material attached on the sealing rubber
or the joint section visually then. Installing a damaged part
such as mentioned above may cause ink leakage.
Ink Tube Stopper
Ink Tube Stopper
B
Ink Tube L
Ink Tube R
B
To Next Page
Loading...
