Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 311
Confidential
DISASSEMBLING PROCEDURE
1. Remove the Control Panel. (p203)
2. Remove the IC Cover (L/R) and the IC Shaft Cover (L/R). (p206)
3. Remove the Maintenance Tank (L/R). (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
4. Remove the Right Cover. (p209)
5. Remove the Left Cover. (p209)
6. Remove the Top Cover. (p214)
7. Unlock the Carriage Unit and move it to the center. (p201)
8. Remove the Ink Tube Guide.
(Step 5 in “4.4.5.6 Cutter Unit” (P. 257))
9. Remove the Ink Tube from the Ink Cartridge Cover L.
(Step 10 to Step 13 in “4.4.6.6 Ink Cartridge Holder L” (P. 284))
10. Remove the two screws that secure the plate, and remove the plate.
(Step 12 in “4.4.6.12 Ink Tube R” (P. 306))
11. Disengage the nine tube holders, and release the Ink Tube L. See Figure 4-167,
4-168.
12. Pull out the Ink Tube L from the hole on the Main Frame. See Figure 4-168.
Figure 4-167. Releasing the Ink Tube L (1)
Figure 4-168. Releasing the Ink Tube L (2)
Ink Tube L
Tube holder
Tube holder
Ink Tube L
Hole
To Next Page
Loading...
